If The door starts to close, then reverses and the opener light blinks.
Then Photo-eye alignment.
The sensors near the floor are out of line or dirty; a clean and re-aim usually restores normal closing.

Remotes, the wall keypad, the button by the kitchen door and the app on your phone all need to agree with the opener. For homeowners in Peel Village we program them cleanly, erase codes from remotes that went missing years ago, and show you how to add a new one yourself when the time comes.
Same fees day or night · Peel Village
Pick the closest, or call (289) 901-5739
Repair & MaintenanceInspection, adjustment, sealing, and section-level repairs.
Springs & HardwareCounterbalance, track, roller, cable, and hinge work.
Openers & AccessOperators, safety sensors, controls, and access systems.
Installation & UpgradesResidential and commercial replacement, upgrades, sectional-door, and rolling-door work.Our technicians visit Peel Village often enough to recognise the door styles that came with each stretch of building, which helps when a spring needs matching or an ageing opener needs a sensible replacement. You get a proper look at the door, straight talk about the choices and work done to last.
Nearby Brampton and Armbro Heights
Your door, running smoothly again.
34 years in business · Ask for a quote: (289) 901-5739
Peel Village
For properties in Peel Village we service the door, the hardware that lifts it and the opener that drives it, and we install new doors and openers when the old ones are done. Residential and commercial work are both covered, each with its own parts, tools and approach.

Photo-Eye Sensor Alignment or Replacement, Extension Spring Replacement, Garage Door Panel Replacement…
Tap a situation. The answer opens here.
If The door starts to close, then reverses and the opener light blinks.
Then Photo-eye alignment.
The sensors near the floor are out of line or dirty; a clean and re-aim usually restores normal closing.
If The door touches the floor and pops back open.
Then Close-limit adjustment.
The opener thinks it hit something; setting the travel limit correctly stops the bounce.
If The door closes but leaves a gap along the bottom.
Then Bottom seal and limit setting.
A compressed seal or a short travel limit leaves daylight; both are simple to correct. Garage Door Bottom Seal Replacement
PeelOntario
Every square is one home in a hundred.
No. Tracks should be clean and dry. Rollers are meant to roll along the track on their own bearings, and a film of lubricant on the track collects grit, thickens in the cold and makes the rollers slide and drag instead. Wipe the tracks with a rag and put the lubricant where it belongs: on the hinge pins, the roller bearings, the spring coils and the bearing plates at the ends of the torsion shaft.
It will match the factory colour your door was made in, which is not quite the colour your door is today, because paint fades in sun and weather. A fresh section can look noticeably brighter than its neighbours, and that difference may not go away with time. If the contrast bothers you, the whole door can be painted with an exterior product suited to the finish. Ask to see the current colour chip against your door first.
Small corrections, yes. If a track bracket needs re-setting or the door needs to come plumb so the fin can meet it evenly, that is done so the new seal is fitted to a door that sits properly. Larger work, such as replacing rollers or a bowed section, is explained and offered as its own job so you can decide on it separately.
Often, yes. Each side has two pulleys, one on the spring and one fixed at the front of the track, and the cable rides over both on every trip. A pulley whose wheel has worn a sharp groove, or whose bearing has stiffened, drags on the cable and adds load the spring has to overcome, which is a common reason the old spring wore early. Pulleys that spin freely and run true can stay.
On-site assessment
Get a technician to your door in Peel Village.
(289) 901-5739, open 24/7.
On-site assessment preferred · (289) 901-5739, open 24/7